Document Outline

• Revision Log
• Read This First
• Table of Contents
• Section 1 - General Safety Practices
  • 1.1 Hazard Classification System
    • Safety Alert System and Safety Signal Words
  • 1.2 General Precautions
  • 1.3 Operation Safety
    • Electrical Hazards
    • Tip Over Hazard
    • Travel Hazard
    • Load Falling Hazard
    • Lifting Personnel
    • Driving Hazards on Slopes
    • Pinch Points and Crush Hazards
    • Fall Hazard
    • Chemical Hazards
• Section 2 - Pre-Operation and Inspection
  • 2.1 Pre-Operation Check and Inspection
  • 2.2 Safety Decals
  • 2.3 Walk-Around Inspection
  • 2.4 Warm-Up and Operational Checks
    • Warm-Up Check
    • Operational Check
  • 2.5 Operator Cab
  • 2.6 Windows
    • Cab Door Window
    • Rear Window
• Section 3 - Controls and Indicators
  • 3.1 General
  • 3.2 Controls
    • Instrument Panel
    • Display Screen
    • Keypad
    • Ignition
    • Park Brake
    • Parking Procedure
    • Transmission Control Lever
    • Load Stability Indicator (LSI)
    • Steering Column Adjuster
    • Joystick
    • Armrest and Right Hand Console
    • Accessory Control Lever
  • 3.3 Anti Theft
  • 3.4 Steer Modes
    • Manual Steering Alignment Mode Change
    • All Wheel Assisted Steering Alignment Mode Change
  • 3.5 Operator Seat
    • Adjustments
    • Seat Belt
  • 3.6 Boom Indicators
    • Boom Extension
    • Boom Angle (AUS)
• Section 4 - Operation
  • 4.1 Engine
    • Starting the Engine
    • Battery Boosted Starting
    • Normal Engine Operation
    • Shut-Down Procedure
  • 4.2 Operating with a Non-Suspended Load
    • Lift Load Safely
    • Picking Up a Load
    • Transporting a Load
    • Leveling Procedure
    • Placing a Load
    • Disengaging a Load
  • 4.3 Operating with a Suspended Load
    • Lift Load Safely
    • Picking Up a Suspended Load
    • Transporting a Suspended Load
    • Leveling Procedure
    • Placing a Suspended Load
    • Disengaging a Suspended Load
  • 4.4 Road Operation (CE)
  • 4.5 Loading and Securing for Transport
    • Tiedown
    • Lifting
• Section 5 - Attachments and Hitches
  • 5.1 Approved Attachments
  • 5.2 Unapproved Attachments
  • 5.3 JLG Supplied Attachments
    • 3508PS, 3509PS, 3512PS, 4008PS, 4009PS & 4012PS
    • 3513PS, 4013PS & 4017PS
  • 5.4 Telehandler/Attachment/Fork Capacity
  • 5.5 Use of the Capacity Chart
    • Capacity Indicator Locations
    • Sample Capacity Chart (CE)
    • Sample Capacity Chart (AUS)
    • Example
  • 5.6 Attachment Installation
    • JLG Quick Attach
    • Manitou Quick Attach
    • Hydraulic Operated Attachment
    • Platform Attachment (If Equipped)
  • 5.7 Adjusting/Moving Forks
  • 5.8 Attachment Operation
    • Carriage w/Forks
    • Side Shift Carriage
    • Fork Positioning Carriage
    • Fork Extension
    • Fork Mounted Hook
    • Quick Attach Mounted Hook
    • Truss Boom
    • Bucket
    • Multi-Purpose Bucket
    • Grapple Bucket
    • Concrete Bucket - Fork Mounted
    • Platform
  • 5.9 Hitches (3508PS, 4008PS, 3509PS & 4009PS)
    • Pin Hitch - CUNA C (Italy)
    • Pin Hitch - CUNA D2 (Italy)
    • Pin Hitch
    • Auto Hitch
    • Piton Frame and Auto Hitch
    • Hydraulic Hitch
• Section 6 - Emergency Procedures
  • 6.1 Towing a Disabled Product
    • Moving Short Distances
    • Moving Longer Distances
  • 6.2 Emergency Lowering of Boom
  • 6.3 Emergency Lowering of Boom If Equipped for Platform
    • Auxiliary Power System
  • 6.4 Cab Emergency Exit
• Section 7 - Lubrication and Maintenance
  • 7.1 Introduction
    • Clothing and Safety Gear
  • 7.2 General Maintenance Instructions
  • 7.3 Service and Maintenance Schedules
    • 8 & 1st 50 Hour Maintenance Schedule
    • 50, 250 & 500 Hour Maintenance Schedule
    • 1000 & 1500 Hour Maintenance Schedule
  • 7.4 Lubrication Schedules
    • 8 Hour Lubrication Schedule
    • 50 Hour Lubrication Schedule
  • 7.5 Operator Maintenance Instructions
    • Fuel System
    • Air Intake System
    • Engine Oil
    • Hydraulic Oil
    • Tires
    • Brake System
    • Transmission
    • Engine Cooling System
    • Battery
    • Windshield Washer System
• Section 8 - Additional Checks
  • 8.1 General
  • 8.2 Load Stability Indicator Test
  • 8.3 Boom Interlock
  • 8.4 Outrigger Interlock (4017PS Only)
  • 8.5 Auxiliary Power (If Equipped for Platform)
• Section 9 - Specifications
  • 9.1 Product Specifications
    • Fluid and Lubrication Capacities
    • Tires
    • Performance
    • Dimensions
    • Declaration of Vibration (CE)
    • Noise Emission Level (CE)
• Index
• Inspection, Maintenance and Repair Log