Document Outline

• Errata A
• Errata B
• Preface
  • About this Manual
  • Conventions and References Used in this Manual
    • Cautions and Warnings
  • Overview of Changes to Previous Edition
  • Reporting Comments or Suggestions Concerning this Manual
  • Customer Support
• Table of Contents
• Chapter 1: INTRODUCTION
  • Description
    • Applications
    • Monitor and Control
    • LNA Assembly
    • Outdoor Enclosure
  • Options
    • Configurations
    • Equipment
  • Specifications
• Chapter 2: SINGLE THREAD SYSTEM INSTALLATION
  • Unpacking
  • Inspecting the Equipment
    • Included Parts
  • RFT Installation
    • Tools Required
    • Vertical Pole Installation
    • Spar Installation
  • LNA and Flexible Waveguide Installation
  • External Connections
    • TX/IF Input (J1)
    • TX/RF Output (J2)
    • RX/IF Output (J3)
    • RX/RF Input (J4)
    • Prime Power (J5)
    • Serial Remote Control (J6)
    • GND
• Chapter 3: REDUNDANT SYSTEM INSTALLATION
  • Unpacking
  • Inspecting the Equipment
    • Included Parts
  • RFT Installation
    • Tools Required
    • Vertical Pole Installation
    • Spar Installation
    • 1:1 Redundant Plate Installation
    • Waveguide Switch Installation
  • RSU-503L Installation
  • External Connections
• Chapter 4: OPERATION
  • System Operation
  • Remote Control
  • Front Panel Display/Keypad
    • Front Panel Controls
    • Menu Explanations
• Chapter 5: THEORY OF OPERATION
  • Monitor and Control
    • EEPROM Memory
    • Remote Interface
    • Terminal Default Conditions
    • Theory of Operation
    • M&C Board Connector Pinouts
    • Test Points and LEDs
  • High Stability Oscillator
    • Specifications
  • IF Local Oscillator
    • Specifications
  • Synthesizer
    • Specifications
    • Theory of Operation
  • Down Converter
    • Specifications
    • Theory of Operation
  • Up Converter
    • Specifications
    • Theory of Operation
• Chapter 6: MAINTENANCE
  • Test Points and LEDs
  • Fault Isolation
• Appendix A: REMOTE CONTROL OPERATION
  • General
  • Message Structure
    • Start Character
    • Device Address
    • Command/Response
    • End Character
  • Configuration Commands/Responses
  • Status Commands/Responses
• Glossary